I implemented the 6-el OWA for 15 m project at the same time as the 7-el monobander OWA for 20 m

Here you will find photos related to this antenna.

I prepared the material for the mast and found this here the next day.

Assembled antenna on the ground

I used the tower support legs to pull the antenna up onto the tower.

Just a little further...

Antenna on the rotating mast

During ARRL CW, I extended the tower a little using a crank handle—the motor drive wasn't working because it was very cold.

First testing of the antenna during ARRL CW 2025

First testing of the antenna during ARRL CW 2025

And this is the full height.

Two months later, I finished cabling so that the antenna could be rotated through its full range. And I aligned it exactly with the Moxon above it :-)